Condensation Checker with Infrared Thermometer

Feature

■ Thermohygrometer and infrared thermometer can be separately used. The thermohygrometer section measures air temperature, humidity, wet bulb temperature, and dew point while the infrared thermometer part measures surface temperature.

■ Difference between the dew point and the surface temperature can be displayed in addition to the dew point itself.

■ Emissivity is adjustable from 0.30 to 0.99. A laser marker helps you specify the measuring spot at a glance.

■ LCD backlight improves readability in a dark place. Also, the power turns off automatically when not in use to prevent from running out the battery even when you forget to turn it off.

Description

■ Caution! This device is for industrial use, not for clinical use.

■ Measured area depends on distance from the object as shown below. Distance-to-spot ratio is roughly 6:1.

■ For the better measurement

A square and a circle represent the object and the measured area respectively.

Best	Get close if possible.	Temperature of other than the object is measured. Get close.

■ JCSS-accredited calibration is only available for air temperature and humidity. (JCSS is an official authority acquired ILAC MRA)

Specifications

Cat. No.		8132-00
Product name		Condensation Checker with Infrared Thermometer
Model name		SK-130ITH
Measuring range	Temperature	0.0 to 50.0°C
	Humidity	10.0 to 95.0%rh
	Surface temp.	−20.0 to 105°C
	Dew point, wet bulb temp.	Calculated within the above ranges
Accuracy	Temperature	±0.6°C
	Humidity	±3%rh (20 to 90%rh, 20 to 30°C) ±5%rh (other)
	Surface temp.	±2.0°C (ambient 23±5°C, emissivity 0.95)
Resolution	Temperature	0.1°C
	Humidity	0.1%rh
	Surface temp.	0.1°C
Sampling time	Temperature, humidity	1 second
	Surface temp.	0.5 seconds
Detector	Temperature	Termistor
	Humidity	Capacitive humidity sensor
	Surface temp.	Thermopile (measured wavelength: 8–14 μm)
Emissivity		Adjustable between 0.30 and 0.99 in steps of 0.01
Distance coefficient		D:S = 6:1 (where D is distance, S is diameter of spot circle)
Laser marker		Source wavelength: 650 nm Output: Less than 1 mW Certified for PSC, a standard based on Japan's Consumer Product Safety Act, as a class II portable laser device.
Operation ambient		0 to 50°C, less than 90%rh without condensing
Power		AAA alkaline battery x4
Battery life		Approx. 20 hours if both laser and backlight are on; 30 hours if only laser is on; 90 hours if both laser and backlight are off (when both the thermohygrometer and infrared thermometer are activated in room temperature)
Material		ABS resin
Dimensions		70 (W) x 170 (H) x 49 (D) mm
Weight		235 g including batteries
Standard accessories		AAA alkaline battery x4